![]() ![]() In either case, you should not have to be going through such a difficult time trying to get a plug and play device working. Once Blue Sherpa is installed plug in your mic and see if the Sherpa software goes ahead and updates the firmware, or. All the while, have your mic not plugged in. Restart your computer and then install Blue Sherpa from this link the second link is the one you want. In either case, you should not have to be going through such a difficult time trying to get a plug and play device working.hope any of this helps out Uninstall G-Hub and remove any instance of the mic from the device manager. Once youve allowed microphone access to your apps, you can change the settings for each app. Then, allow apps access to your microphone. maybe the levels are just waaaay low? in either case if turning the gain up doesnt help, you might have a defective mic In Allow access to the microphone on this device, select Change and make sure Microphone access for this device is turned on. For some reason, when I record sound through the Yeti on the Sound Recorder or any other sound app, it sounds really poor. As far as the Yeti goes, make sure its plugged into a USB2.0 port, has the input settings set to default, and that no extra software is interacting with the input (such as a Realtek HD Audio Manager). I have a Blue Yeti X microphone, and I am running Windows 11 on a HP Pavillion with an Intel Core i7. ![]() This was solved by plugging the headphones into the mainboards 3.5mm jack instead. Hmmm.doubt it could be a power problem since its running off of 5v supplied from usb.also doubt you would be able to use it as an output device if it was you tried playing around with the volume/gain settings in recording devices settings? also set the yeti to omni-directional mode and try snapping from different sides.maybe one or two of your mics went dead? (think yeti has 3 internally).also might help to allow listening through a set of headphones. Itd give the Sonys I was using some weird static sound. The mic stopped working a few days ago in windows 7, i tried everything to the point to update to windows 10, but it was useless, i test it in my lap and it worked the first 2 days, then when i plugged it in again yesterday, it started to download drivers from windows update or something like that, and stopped working too!!!! and i was like. The only way the volume level bars can move is when i switch between modes. The mic is set as the default recording device, it just doesnt pick up sound (it has the green check-mark next to it). Yes im able to use it as an output device, when i plug my headphones to it i can listen everything, so the yeti is not the problem i guess?. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |